PLEASE NOTE THAT HELMETS ARE CUSTOM-BUILT AND TAKE 4-6 WEEKS.

The Vapor LS is loaded with many of the popular features found on our Vapor SC and is perfectly suited for racers looking for a helmet that offers additional noise attenuation but not requiring a fresh air port. Aggressive chin-bar styling provides for additional room for the microphone while integrated vents offer cooling, fog-free comfort. Superior ambient noise attenuation is achieved through the use of Impact’s proprietary insulation foam creating a quieter race environment and reducing the potential for noise fatigue. The Impact Vapor LS also offers a tapered design allowing for additional clearance between the helmet and the frontal head restraint device, thus minimizing interference between these two safety systems. Manufactured using Impact’s exclusive “Intelligent Gray Matter” inner liner (a variable-density, single-piece helmet liner) and upholstered with fire-retardant soft-knit Nomex® material for superior comfort and fire protection, the Vapor LS also includes removable cheek pads. Optionally available cheek pads are available in a variety of thicknesses and configurations to provide a custom fit. A wide-angle, wrap-around eye port, a Kevlar® chin strap with dual D-ring closure, and a 1/8” polycarbonate shield with exceptional visual acuity finish off the newest addition to Impact’s line of Made in the USA helmets.

*Add Options like FHR Posts, an additional shield, or tear-offs below. These must be ordered as a separate item, but can be added to your new helmet by the factory if specified.

• SNELL SA2020 CERTIFIED
• Shell construction featuring proprietary American space-age Carbon-Kevlar tri-weave composite.
• Aggressive chin-bar styling provides for additional room for the microphone.
• Integrated vents offer cooling, fog-free comfort.
• Tapered lower design allowing for additional clearance between the helmet and the frontal head restraint device.

Care & Cleaning

• Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
  
  SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
  
  HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
  
  HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
  
  MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
  
  HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.